SEM: only 2 landing gear LEDs active

[Viking]

Hello!

I have an issue with my SEM which is attached to my Gladiator NXT R.

First here's my system info:
1 - Device model and version: Gladiator NXT R with SEM
2 - Controller Firmware version: v2.085
5 - VKB Device Config v0.92.17

And that's the issue:

• Only the top and lower left landing gear LEDs illuminate when moving the landing gear lever (button #62) down. The lower right (LED #19) does not illuminate.
• This behavior occurred suddenly - when I first set the SEM up all of them went green.
• The LED itself is not broken: tested with TEST/MISC/LED N
• In the LED configuration panel I noticed, that for the mentioned LED (#19) there is no event defined. The other two landing gear LEDs (#17 and 18) are linked to Button 62 (that's the gear down position)
• However, I cannot add an additional line for Button 62 linking it to LED #19.

Please help!

Many thanks in advance!

[Ron61]

And what prevents you from scrolling below?

[Viking]

Let me clarify: I certainly did add another line for LED 19 but that is not being accepted somehow. After I send the new configuration, the new line disappears.

[fallout9]

That line should be there by default. The missing LED could happen if you changed the axes detents settings without resetting to default and pressing the Find&AutoCalib.
I would say to upgrade to the latest firmware and software, then do a reset to default and click on Find&AutoCalib again.

[Viking]

That did the job! Thanks for the prompt support!

[Cloudless]

I just posted the same issue, I will try that fix tomorrow!