VKB-SIM

Hello!

I have an issue with my new SEM which is attached to my Gladiator NXT R.

First here's my system info:
1 - Device model and version: Gladiator NXT R with SEM
2 - Controller Firmware version: v2.085
3 - Number and type of springs used: standard
4 - Тype of cams used: standard
5 - If VKB original software is used, please always mention its version: VKB Device Config v0.92.17

And that's the issue:

• after updating to the new firmware or defaulting the joystick all buttons on the stick and the SEM are available. The SEM is also recognized as external device (see screenshots). On the stick and the SEM all buttons are lit:
  

  

  here the buttons for flaps, gear and the mode switch are lit

  

  SEM recognized

• however, after calibration the SEM is not recognized anymore:
  

  

  buttons for flaps, gear and the mode switch are dim

  

  SEM not recognized

Please help!

Many thanks in advance!

Have you watched this video?

Well, yes - and followed all the steps at least at the first setup. However, after updating the firmware, I did not perform the "find&autoconfig" step (5:00). That made the difference - everything is working fine now!

Thanks for helping!

What are you supposed to do when your VKBdevCfg has no find&autoconfig button in it?

Press Default button again and the Find&AutoConfig will show up.

You may be using a very old firmware and configurator. That didn’t have such a function yet.