SEM not recognized after calibration

Moderator: AdminGroup

Viking
Posts: 22
Joined: Fri Sep 17, 2021 9:52
Has thanked: 1 time
Been thanked: 1 time

SEM not recognized after calibration

Postby Viking » Mon Nov 22, 2021 11:29

Hello!

I have an issue with my new SEM which is attached to my Gladiator NXT R.

First here's my system info:
1 - Device model and version: Gladiator NXT R with SEM
2 - Controller Firmware version: v2.085
3 - Number and type of springs used: standard
4 - Тype of cams used: standard
5 - If VKB original software is used, please always mention its version: VKB Device Config v0.92.17

And that's the issue:
  • after updating to the new firmware or defaulting the joystick all buttons on the stick and the SEM are available. The SEM is also recognized as external device (see screenshots). On the stick and the SEM all buttons are lit:
    Screenshot 2021-11-22 091949.png
    here the buttons for flaps, gear and the mode switch are lit
    Screenshot 2021-11-22 092050.png
    SEM recognized
  • however, after calibration the SEM is not recognized anymore:
    Screenshot 2021-11-22 092315.png
    buttons for flaps, gear and the mode switch are dim
    Screenshot 2021-11-22 092338.png
    SEM not recognized
Please help!

Many thanks in advance!

Ron61
Posts: 3261
Joined: Tue Jan 15, 2013 23:56
Location: г.Минск
Has thanked: 44 times
Been thanked: 637 times

Re: SEM not recognized after calibration

Postby Ron61 » Mon Nov 22, 2021 18:21

Have you watched this video?

Viking
Posts: 22
Joined: Fri Sep 17, 2021 9:52
Has thanked: 1 time
Been thanked: 1 time

Re: SEM not recognized after calibration

Postby Viking » Mon Nov 22, 2021 19:18

Well, yes - and followed all the steps at least at the first setup. However, after updating the firmware, I did not perform the "find&autoconfig" step (5:00). That made the difference - everything is working fine now!

Thanks for helping! :D

cobra9delta
Posts: 5
Joined: Fri Nov 26, 2021 9:10

Re: SEM not recognized after calibration

Postby cobra9delta » Fri Nov 26, 2021 9:46

What are you supposed to do when your VKBdevCfg has no find&autoconfig button in it?

User avatar
fallout9
Posts: 5158
Joined: Wed Oct 03, 2018 20:37
Has thanked: 207 times
Been thanked: 1217 times

Re: SEM not recognized after calibration

Postby fallout9 » Fri Nov 26, 2021 10:11

Press Default button again and the Find&AutoConfig will show up.

Ron61
Posts: 3261
Joined: Tue Jan 15, 2013 23:56
Location: г.Минск
Has thanked: 44 times
Been thanked: 637 times

Re: SEM not recognized after calibration

Postby Ron61 » Fri Nov 26, 2021 11:19

You may be using a very old firmware and configurator. That didn’t have such a function yet.


Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 30 guests