MCG Ultimate Gate Cont as POV1

Suraklin · Postby **Suraklin** » Mon Nov 22, 2021 1:11

Hello,

i got a little bit of a problem or maybe only a question

.
I changed the Master Mode analogue stick to a hat switch. That worked without a problem. I want to use the Gate Cont as POV. I found how i can get it to work as POV2 here in the forums and and that works.
My question is now, is it possible to map Gate Cont as POV1? Because i don't like it to create a second POV so that i can use Gate Cont as POV.

Postby **Ron61** » Mon Nov 22, 2021 10:41

Yes, you can.
Declare in Global # 1 POV, in External set the GateCont axes from 5,6 to 3,4, in Profile-Buttons make the central button, like the uSSw Pov1 switch, in POVs for the first (and only), set the control axes as 3,4 s by switching On/Off.
Not only that, with a push-button MasterMode, you can configure it like POVs2.
Those, actually swap them from red to blue and vice versa for the other.

Suraklin · Postby **Suraklin** » Mon Nov 22, 2021 18:01

Hello,

thank you for your help.
I think i understood most of it. But can you help me with the part "in External set the GateCont axes from 5,6 to 3,4," i cant realy find where i do this.

Postby **Ron61** » Mon Nov 22, 2021 18:10

You can see more details here, in my penultimate post, the first screenshot.

Suraklin · Postby **Suraklin** » Mon Nov 22, 2021 20:34

Hello,

Thank you very much for your help. Now its working like i want it.
If some one is interested how it was done i will post some screenshots.

First i reset the stick with default. Then i set the Gate Cont axis to 3,4 from 5,6. I also disabled the axis from Master Mode because i am using the HAT insert.