Hello,
Thanks for your devices!
But, I bought the VKB-SIM T-RUDDER PEDALS MK.IV and I wanted to add it on the same Blackbox of my Gunfighter.
The rudder didn't work directly after it was pluged, I re-started my setup from scratch and flashed my Blackbox with the last version.
Now my joystick and my rudder works but all the buttons numbers changed. Before, my first button had the number 1 et now the same button have the number 105.
Can we reset the Buttons numbers?
VKBsim Gunfighter TMW XT v2.071 Mk2
VKB Device Config v0.92.06
NJoy32 firmware v2.07.0
Can we change the Physical layer
Moderator: AdminGroup
- fallout9
- Posts: 5184
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Can we change the Physical layer
Click on the name of the joystick in the device list, then click on the Default button under Tools tab and recalibrate.
Re: Can we change the Physical layer
It works but when I write parameters into device, the button's number change again
https://youtu.be/y0xHH2z6fC8
https://youtu.be/y0xHH2z6fC8
- fallout9
- Posts: 5184
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Can we change the Physical layer
There's no need to press Set at the end. Just reset to Default, Start Calibr, calibrate, End Calibr, good to go.
Who is online
Users browsing this forum: No registered users and 60 guests