VKB-SIM

I have a Gladiator NXT (Premium Right handed). I am attempting to set the buttons, and want to use a macro.
The "Macro" tab does not appear when I run VKBDevCfg-C. I tried putting, "user=developer"
into the zconfig.ini file (I saw this suggestion in a 4 year-old post), but it made no difference. Any suggestions?

Flash your NXT with the firmware attached below following these steps:
1. Download the configurator;
2. Download the bootloader;
3. Download the attached firmware;
4. Unzip all the 3 files in the same folder;
5. Launch VKBDevCfg as Admin and click the Bootloader button under Tools tab;
6. Navigate to the firmware file folder and load it up;
7. After the bootloader finishes launch VKBDevCfg and click the Default button under Tools tab;
8. Go to Test/Axes1 tab and click on the Start Calibr button;
9. Move your pitch, roll and yaw axes all the way, slowly at the end;
10. Move the mini-throttle up and down;
11. Press the End Calibr button.
Now you should have the Macros tab visible.