VKB-SIM

привет всем!
I was able to successfully flash and calibrate the ultimate joystick, but when I tried to repeat the process with the rudder, it remained invisible. I scoured YouTube with a plethora of different word assemblies...zilch. I repeated the same successful process with the joystick unplugged, but I am ignorant of whether or not that is a factor: do they have a master/slave configuration, like Virpil peripherals? I scrolled through several pages, not finding anything that looked similar to my issue. I am brand new to VKB firmware/software.
Thanks for reading,
G

Are the rudders plugged to their own Black Box or together with the Ultimate?

Together.

Then they won't be seen in the device list, as they became part of the principal device. You'll have to run a calibration on both stick and rudders at the same time.
Do you have the twist version of the U or no-twist?

Ahhh! Gotcha. It's a no twist. Thank you.

With no-twist version you're good with the above stated.

The Ultimate's firmware will integrate the rudder, correct?

That's right, plugging them into the same BB would make the GFIII/U to assimilate the rudders and act as a single device.

Thank you very much!