привет всем!
I was able to successfully flash and calibrate the ultimate joystick, but when I tried to repeat the process with the rudder, it remained invisible. I scoured YouTube with a plethora of different word assemblies...zilch. I repeated the same successful process with the joystick unplugged, but I am ignorant of whether or not that is a factor: do they have a master/slave configuration, like Virpil peripherals? I scrolled through several pages, not finding anything that looked similar to my issue. I am brand new to VKB firmware/software.
Thanks for reading,
G
T-Rudder not recognized in Configurator
Moderator: AdminGroup
- fallout9
- Posts: 5250
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 209 times
- Been thanked: 1230 times
Re: T-Rudder not recognized in Configurator
Are the rudders plugged to their own Black Box or together with the Ultimate?
- fallout9
- Posts: 5250
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 209 times
- Been thanked: 1230 times
Re: T-Rudder not recognized in Configurator
Then they won't be seen in the device list, as they became part of the principal device. You'll have to run a calibration on both stick and rudders at the same time.
Do you have the twist version of the U or no-twist?
Do you have the twist version of the U or no-twist?
- fallout9
- Posts: 5250
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 209 times
- Been thanked: 1230 times
Re: T-Rudder not recognized in Configurator
With no-twist version you're good with the above stated.
- fallout9
- Posts: 5250
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 209 times
- Been thanked: 1230 times
Re: T-Rudder not recognized in Configurator
That's right, plugging them into the same BB would make the GFIII/U to assimilate the rudders and act as a single device.
Who is online
Users browsing this forum: Google [Bot] and 54 guests