When disassembling my Mamba with MCG grip to replace a swtich that had broken one of the connectors on the adapter board broke off
It's a 4 pin angled connector I think they are called JST connectors.
However they come in a bewildering number of types and I was looking for some help to establish the correct type so as I can get a replacement to solder a new one back on.
In the picture I've labelled it with a red arrow I tried to include a page from the instructions but the file won't load.
In the instructions on page 2 the board is item 4 and the plug that's broken off is X2 which is labelled on the board
Be very grateful if somebody from VKB could assist me
Mamba MkIII JST PLUG HELP
Moderator: AdminGroup
Re: Mamba MkIII JST PLUG HELP
Attached is the page from the instructions
Board is item #4
Plug that's broken off is X2 as labelled on the board
As an alternate if that board is available as a replacement I'd gladly purchase it instead
Board is item #4
Plug that's broken off is X2 as labelled on the board
As an alternate if that board is available as a replacement I'd gladly purchase it instead
-
- Posts: 499
- Joined: Fri Mar 18, 2011 0:12
- Location: Украина
- Has thanked: 131 times
- Been thanked: 57 times
Re: Mamba MkIII JST PLUG HELP
Ron61 wrote:It is necessary to select with a step of SH 1mm and the required number of pins.
Dear Colleagues.
I dare to correct you.
The required connector is sized with a pitch of 1.25 mm..
You can buy it here:
https://aliexpress.ru/item/32754080045. ... 1833047832
Re: Mamba MkIII JST PLUG HELP
Thank you that's fantastic, I ordered the plugs from your link, very much appreciated.
I had searched Ali Express before but thinking the pitch was 1mm could not find anything suitable
John
I had searched Ali Express before but thinking the pitch was 1mm could not find anything suitable
John
Who is online
Users browsing this forum: No registered users and 84 guests