Mamba MkIII JST PLUG HELP

[Weegie]

When disassembling my Mamba with MCG grip to replace a swtich that had broken one of the connectors on the adapter board broke off

It's a 4 pin angled connector I think they are called JST connectors.

However they come in a bewildering number of types and I was looking for some help to establish the correct type so as I can get a replacement to solder a new one back on.

In the picture I've labelled it with a red arrow I tried to include a page from the instructions but the file won't load.

In the instructions on page 2 the board is item 4 and the plug that's broken off is X2 which is labelled on the board

Be very grateful if somebody from VKB could assist me

[Weegie]

Attached is the page from the instructions

Board is item #4
Plug that's broken off is X2 as labelled on the board

As an alternate if that board is available as a replacement I'd gladly purchase it instead

[Ron61]

It is necessary to select with a step of SH 1mm and the required number of pins.

[Weegie]

Thanks Ron

Your reply is very much appreciated I'll have a look and see what I can find

If I do find a suitable replacement I'll post up a link to it

John

[Юрий]

It is necessary to select with a step of SH 1mm and the required number of pins.

Dear Colleagues.
I dare to correct you.
The required connector is sized with a pitch of 1.25 mm..

You can buy it here:
https://aliexpress.ru/item/32754080045. ... 1833047832

[Weegie]

Thank you that's fantastic, I ordered the plugs from your link, very much appreciated.

I had searched Ali Express before but thinking the pitch was 1mm could not find anything suitable

John