Gunfighter Mk.III + MCG Ultimate with two springs

[seventhseeker]

Hi everyone (and sorry for my english),

I received a Gunfighter Mk.III + MCG Ultimate a few days ago, and I must say I'm absolutely delighted!

Within a few days I changed the stock springs for a #40 on each axis, and it works great.
But I wanted to add a little resistance, and I added one more spring. In total #40 + #20 on each axis.

The problem is when I move the grip to the end of the X axis (to the left), the outer spring collides with the gunfighter cover, and the spring is released.

I think the springs are well positioned, but I'm attaching some photos and video to illustrate the problem.

https://www.dropbox.com/s/1bfvvvm64o8wf ... 9.mp4?dl=0

Has anyone else had this problem?

Thanks a lot!

[fallout9]

Glad you like it, but sad to tell you that you've installed the springs in the wrong position They're supposed to be back-to-back, with their 'bellies' facing outwards. Check this explanatory video, especially the springs installation part.

[admiki]

Just rotate spring closer to the cam by 180 and you're good to go

[seventhseeker]

Perfect!
I didn't observe that detail, and I installed both springs at the position of a single spring.

Thank you very much to both!