Gunfighter Mk.III Setup for MCG Ultimate

[Javaman]

Hi,

I just recently ordered the MCG Ultimate to replace an existing MCG Pro on a Mk.III base.

May I know what's the recommended setup for the Mk.III base? Cams, springs and things like that?
Probably the same base setup with the recent MCG U + MK.III base bundle.

Thanks in advance.

[fallout9]

There’s no special requirement or recommendation for using the MCGU.

[Stonehenge]

At the moment, i use 2 single 20s springs for my MCG Pro. Am I right with the assumption that the Ultimate might be too heavy for this setup? So that I probably have to take 2x 30s to get the same result?

[fallout9]

Warthog is heavy, but metal does not necessarily means heavy by default if you combine good design and engineering You'll be surprised.

[Drano]

The spring tension is all about how you like it. Only "rule" is not exceeding the max of, is it a pair of 40s or is it 50s? I forget actually. That's what's so cool about this brand. You're free to tweak it however you want. I don't have an ultimate, just the original MCG-Pro. I recently added a 200mm extension and felt that with the extra leverage involved, the spring force I liked when it was just attached to the base, that was on the lighter side, was now WAY too light. No biggie. I just added more spring tension to where it felt right to me again. In short, I don't think the extra weight of the new grip is as much of a factor without any extensions. That's where it's gonna be noticeable. At least in my experience.

[Javaman]

Got my MCGU yesterday. Adding #20 springs on each axis seems to work for me (Tabletop, no extensions).

[mplus]

Centering ok after adding #20 springs on each axis?
Each axis have now 2 #20 springs?
Is that correct?

[Ron61]

If you are satisfied with this, then completely. Maximum allowable 2x50 per axle.

[admiki]

2x50 or 2x50A?
It seems those are not the same.

[Javaman]

Centering ok after adding #20 springs on each axis?
Each axis have now 2 #20 springs?
Is that correct?

Centering is really good for me.

Assuming the information i got somewhere that base comes with #20 springs on each axis out of factory, then Yes, each axis now have 2 #20 springs.