VKB-SIM

Hi,
I'm trying to use DR function, but I'm unable to make it work. I thought it would make my joystick more precise (similar to DPI button on mouse). But it doesn't affect X/Y axes in any way. This is what I did:

1) Global/Common - D.Rate set to 1:4
2) Profile/Axes - Identified axes X/Y under 1 and 2 AxID
3) Profile/Buttons/Physical - Set button 1 to Fix axes, DR type, applied to axes 1 and 2
4) Set LED on Blackbox to signal Fix Axis is on.

When I press the button nr. 1, LED on Blackbox appears, so it looks like the button is working correctly. But X/Y axes are unaffected, they still have full range, no extra sensitivity, no 1:4 compression in response curve. What am I doing wrong, can someone help me please?

Thanks!

Try to check FA on Global - Common tab. It enables Fix Axes functions.

So simple! It works.

Thanks again.

Victorus wrote:Try to check FA on Global - Common tab. It enables Fix Axes functions.

The button no longer exists in 0.92.51, I did all the steps required but that box is not shown.

Obsolete FW/SW. SW0.92.76, FW 2.13e - it works. Try.

the support\downloads has the same software and firmware as I have.

Victorus wrote:Obsolete FW/SW. SW0.92.76, FW 2.13e - it works. Try.

I have the same issue. I don't have FA box with shown FW/SW

Aaa. Understood! FA box is not necessary now, this function remain active continuously. My mistake - I had wrong button. Poll box in physical layer screen helped my to identify button correctly.