Gunfighter MKI with SCG
Blackbox MKI firmaware V2.00.7
Linear Cams with No.30 springs
Device Config v0.91.54
The X and Y axis go dead (do not register input) intermittently. The other axis are fine. I have two gunfighters and this only happens on the right one. The only way to get them back up is to reboot the the blackbox. I've tried swapping Black Boxes and Swapping bases/sticks but it's always the SCG Right which leads me to suspect it's a firmware issue instead of hardware. I'm not sure which firmware version I stared noticing it (I think it was near 1.8x) Any guidance would be greatly appreciated
Thanks
Gunfighter X/Y Axis "going to sleep"
Moderator: AdminGroup
-
- Posts: 3277
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Gunfighter X/Y Axis "going to sleep"
Check in the control panel in the "Device Manager" - "USB Controllers" branch on each device in the "power management" properties to see if the "Allow this device to be turned off to save energy" function is activated. You need to uncheck the box. And check it in the "HID Devices" branch.
Who is online
Users browsing this forum: No registered users and 111 guests