VKB-SIM

I just received the T-Rudder MKIV. Plugged them into the blackbox that shipped with it via the supplied ethernet cable, connected the blackbox to my Windows 10 PC via the supplied USB cable. Windows 10 recognized the device and even shows the, "VKB-Sim T-Rudder" in the Game Controllers utility (Windows 10 utility), but movement of the pedals does not show any movement in the, "Test" tab. Instead it shows 100% right rudder (X-Rotation). So I downloaded the, "VKB Device Config v0.91.34", ran it, I can see the, "VKB-Sim T-Rudder" in the top of the utility but I notice that the "Device" dropdown menu has, "Generic device" selected. Am I supposed to select something in that box in order to get the pedals to work? When I go to the "Test" tab in the utility I cannot see value changes when moving the pedals.

So figured I would try and update the firmware. I was able to do that successfully. So I went from like v1.96A to v1.99A. Still not seeing value changes in the test tab of the VKB Device Config.

Any ideas? Anyone?

Open VKBDevCfg, click on the Test tab, then on the Axes tab. Now click on the Tools tab and there click on the Default button. After the device restarts click on the Start Calibr button and press left on your rudders, then right - a few times, slowly and all the way to the end. After that click on the End Calibr button and you're good to go!

Hah, oh wow.... So the default button was the one thing that I did not do. I started calibration, stopped calibration, and did lots of other things but the "default" button must have fixed it. Thank you very much!