Configuring Gunfighter Pro Mk. III grip with MCG Twist Adapter
Posted: Wed Jul 08, 2020 13:46
Hi can anyone advise me on setting up the Gunfighter Pro Mk. III grip with the MCG Twist Adapter? I put in a support ticket several weeks weeks ago, but so far there has been no response.
After watching several helpful videos, I managed to install the adapter in the grip. I am now trying to configure it, but unfortunately the videos that I have watched all stop short of actually showing how to do this part.
I have downloaded the latest configuration software (VKB Device Config v0.91.12) and the user manual (controller_2_11_En.pdf), which I think are the correct ones. However, I can't find anywhere in the manual where it explains how to set up the Twist Grip adapter. The only information that I have been able to find is on the store page for the adapter, where, in the Installation section, it says:
· Re-configure the BlackBox (easy – just check two boxes in VKBdevCfg)
· Re-calibrate your Gunfighter w/ MCG including the newly added Z-axis
· Start flying
Unfortunately it doesn’t tell me which two boxes I need to check, and as a novice at setting up advanced joysticks I can’t see any boxes in the Configurator that obviously relate to the adapter.
Can anyone please tell me which configurator boxes I need to check so that I can set up the twist adapter, or point me to a video that actually shows this process?
Thank you.
After watching several helpful videos, I managed to install the adapter in the grip. I am now trying to configure it, but unfortunately the videos that I have watched all stop short of actually showing how to do this part.
I have downloaded the latest configuration software (VKB Device Config v0.91.12) and the user manual (controller_2_11_En.pdf), which I think are the correct ones. However, I can't find anywhere in the manual where it explains how to set up the Twist Grip adapter. The only information that I have been able to find is on the store page for the adapter, where, in the Installation section, it says:
· Re-configure the BlackBox (easy – just check two boxes in VKBdevCfg)
· Re-calibrate your Gunfighter w/ MCG including the newly added Z-axis
· Start flying
Unfortunately it doesn’t tell me which two boxes I need to check, and as a novice at setting up advanced joysticks I can’t see any boxes in the Configurator that obviously relate to the adapter.
Can anyone please tell me which configurator boxes I need to check so that I can set up the twist adapter, or point me to a video that actually shows this process?
Thank you.