VKB-SIM

Hi, I am having trouble calibrating and using the ministick on my SCG premium. I cant tell if it is a hardware or software issue. It seems to stick all the way left sometimes. It also does not appear to register the full range of values in the X axis (left/right). Any ideas would be appreciated. Thank you!

That ministick has to be calibrated in order to work properly. To calibrate it make sure the axes mode is active by going into to Tester/Axes and check if the axes are moving; if they're not moving then press on the center button of the ministick to switch in axes mode. After that you go ahead and calibrate all the axes, like here: https://youtu.be/mCajFZ9e9gw

Yep tried that. The vertical axis responds normally but the horizontal seems bad.

Post a screenshot with Profile/Axes. Also a screenshot with the tester showing erratic behavior if possible.