SCG Ministick (A1) problems.
Moderator: AdminGroup
SCG Ministick (A1) problems.
Hi, I am having trouble calibrating and using the ministick on my SCG premium. I cant tell if it is a hardware or software issue. It seems to stick all the way left sometimes. It also does not appear to register the full range of values in the X axis (left/right). Any ideas would be appreciated. Thank you!
- fallout9
- Posts: 5182
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: SCG Ministick (A1) problems.
That ministick has to be calibrated in order to work properly. To calibrate it make sure the axes mode is active by going into to Tester/Axes and check if the axes are moving; if they're not moving then press on the center button of the ministick to switch in axes mode. After that you go ahead and calibrate all the axes, like here: https://youtu.be/mCajFZ9e9gw
Re: SCG Ministick (A1) problems.
Yep tried that. The vertical axis responds normally but the horizontal seems bad.
- fallout9
- Posts: 5182
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: SCG Ministick (A1) problems.
Post a screenshot with Profile/Axes. Also a screenshot with the tester showing erratic behavior if possible.
Who is online
Users browsing this forum: No registered users and 70 guests