Gladiator K Calibration

[Arg0n89]

I just bought a left and right Gladiator K set of joysticks. I plugged them in and I tried to calibrate them in the config software but I can't get the Rot X and Rot Z to work. I clicked the A1 button to activate the mini stick but that didn't work on either and the red light didn't go on when I clicked either

[fallout9]

Isn't the red LED on the base flashing? That means the grip is not seated properly on the base. See here how to install it: https://youtu.be/ac3Jmaw17jE
After properly installing the grip, run the calibration and hold the A1 center button pressed for 2-3 seconds. When the small LED light comes up on the grip then the ministick axes are active.

[Arg0n89]

Thanks for the response. It doesn't flash red but when I check the button menu in the tools menu, it shows that I am pressing the mini stick in so I am pretty sure it's seated properly since I did follow that video. Also no communication error in the external devices menu

[Arg0n89]

And to add the red light in the base does flash red once I press the trigger during calibration which seems to mean that calibration didn't work

[fallout9]

Run the calibration please through VKBDevCfg, follow this video from the time stamp (you don't need the re-flash part): https://youtu.be/Xw91bRNsrPs?t=154

[Arg0n89]

Thanks but that is exactly what I am trying to do. I can't finish the calibration because I can't activate the mini stick

[fallout9]

Ministick is RotX and RotY. Why are you Asking about RotZ though? Have you changed things in Configurator?
Doesn't matter, press the Default button and try again to calibrate.

[Arg0n89]

So my mistake saying RotZ. I can't do RotX and RoyY. I clicked default to reset both and still nothing when I hold in the mini stick

[fallout9]

Do you have the standard or premium version of the grips?

[Arg0n89]

I have the standard version that cost $149 (Gladiator-K - SCG)

[fallout9]

Standard Kosmosima has no ministick, just a regular hat.

[Arg0n89]

Okay thanks that's helpful. I just don't understand why it flashes red after i say end calibration then? I thought that meant the calibration wasn't finished? I always do Axis X, Axis Y, Rot Z and Axis Z

[fallout9]

If it's a short flash it's fine, if the LED's permanently flashing then there's a problem with calibration, maybe one of the axes haven't been covered the whole range. There's pitch, roll, twist and mini-throttle on your device, make sure you're going end to end on all these axes when calibrating.

[Arg0n89]

Should I be ending the calibration by clicking "end calibration" or pressing the trigger?

[fallout9]

If you're doing the mechanical calibration press the trigger, if you're doing it through software press the End Calibr. button.