Calibration Gladiator-K

[FlyinPinkPanther]

Hello,

I recently purchase a Gladiator-K. Limited Edition
Box has SCG-R | P

I plugged it in to do the quick calibration, but that did nothing. So I went to the website and followed the video.
Everything was fine until I got to the part where you lick on bootloader.
It gives me a continuous error. Moreover, contrary to the video, it scrolls the error before I choose the specific file. (I do not know if that is important).

I have a Dell G7 laptop with Windows 10 64 bit system.

I have been fooling with this for over two hours. I used different USB ports and restarting my system twice. I only have the one laptop (wife has an apple)

HELP!

[fallout9]

Please don't lick the bootloader, that is not covered by warranty!!! )))))))))))

Your device is brand new and doesn't need flashing. Do just the calibration part, here's the link with time stamp: https://youtu.be/Xw91bRNsrPs?t=157. Basically just open the VKBDevCfg, press the Default button, go to Test/Axes, Start Calibr, calibrate, End calibr and that's it.

[FlyinPinkPanther]

When I did that, the yaw (Twist) and the hat shown in the video does not do anything.
The Pitch, roll and throttle works though.

------

I went into the game settings and I was able to program the buttons on the base, but nothing on the stick itself.

-----------------

EDIT: Based on the above I decided to recheck my connection, so I disassembled the stick and reassembled. Apparently, I was not fully installed when I screwed in the stick to the base.

so that problem solved.