3-pin connector wire broken in Kosmosima grip
Posted: Tue Jun 16, 2020 8:56
Hello, the black wire connected to the 3-pin connector on the Kosmosima grip broke from normal use of the twist axis. The twist axis had started disconnecting momentarily while using it, so I disassembled the grip and the twist housing and discovered that the black wire had broken off from the 3-pin circuit board at the base of the grip.
What is the best path forward to fixing this? To do it myself, I assume I would need to solder the black wire back to the pin.
What is the best path forward to fixing this? To do it myself, I assume I would need to solder the black wire back to the pin.