VKB-SIM

Hi.

I have the mkII with GFpro and that works fine, I can flash it and load cfg file.

I have just received the KG12 and I can not get any response from the buttons.

I unplugged the usb from box
I switched the grips
I plugged in the USB
I flashed the firmware with "_BlackBox_GF_KG_v1_98_F.vkb"

but i don't get any response from KG12.

When i check external device it seems to be communication error!

Try with this firmware: https://mega.nz/folder/gx0mFQIR#ci756YS ... e/go8jTDDY (you have the orange Black Box right?) matched with this software: https://mega.nz/folder/Vk8AzAAR#eqrWwOz ... e/0stDhL5D
Follow the guide: https://youtu.be/fU4CbKhGm_w

I followed the video step by step ..
Upload firmware
Set to default
Calibrated axis and they work.. I still don't have any reactions from buttons.

I still have the screen that i attached before .. indicating "no communication"

Shall I try again with GF Pro stick??

Well I did try the MCG Pro stick folloing the same procedure ... works fine.

There is only one reason left - the physical contact of the grip and base. That is its absence. Carefully inspect the spring contacts for bending, seizing when recessed.

I don't feel any difference between MCG and KG12, when depressing the pins.

On BB any Led blinks when installing KG12? Show a screenshot of the Clobal-External tab.

Yes the RED blinks until I select KG12, then it stops.

When I press default it reverts to Gladiator ...

Click the Default button and reconnect the USB cable. Has anything changed?

Clicked the default button -> reverts back to Gladiator and reboots
Unplug the USB and reconnect USB -> No change, only request for calib of axis, no buttons.

And RED LED and comms error in config software.

https://drive.google.com/file/d/1GeWKAi ... sp=sharing

This is what the working configuration looks like. After resetting, you only need to calibrate all the axes.

This I have done .. the axises are working just fine .. but NO BUTTONS are responding. Not inthe CKB configurator nor in DiView.
I have tried as Gladiator and also as KG12 .. same result. NO BUTTONS are responding
I have also reflashed with MCG stick and then all buttons and axises work.

https://drive.google.com/file/d/1TylcdG ... sp=sharing

As long as there is no connection between the handle and the base, there can be no talk of any button operation. Have a tool and skills to measure the voltage at the connector?

Yes .. what do you want me to measure .. voltage or continuity? and where from / to?