Gunfigher Mk II MCG Pro Eng X Axis broken

[Marc]

yes, reconnected as shown on your picture from above!

[Ron61]

Your X axis and trigger axis are not calibrated. Show the Profile-Axes-Logical Axes tab.

[Marc]

there you go

[Ron61]

Change the MPL value to 11 (now it costs 10), press Set and calibrate. We show a screenshot.
p.s. no need to quote the message if the answer comes immediately after it - it’s already clear to whom you are responding.

[Marc]

changing the MPL value from 10 to 11 for lines 1,2 and 7 confirm?

[Ron61]

Only for 1 - where the X axis.

[Marc]

done. now the movement to the right is 100% correct but to the left, it remains the same. Do you want a screenshot of some particual tab?

[Ron61]

Show the Profile-Axes tab.

[Marc]

here you are

[Ron61]

Try firmware 1.987 and the configurator 0.91.12.

[Marc]

done! now, moving the stick to the right is the same as before, its not 100%, it stops earlier but maybe because the mpl is back at 10. And to the left, no change at all

[Ron61]

Launch Joytester and turn off the display of all axes except the X. Take a screenshot when moving the handle to the full range.

[Marc]

done:

[Ron61]

The full range also implies the curve at the bottom of the graph. And after flashing and calibrating, show the Profile-Axes (and Logical Axes) tab.

[Marc]

there you go. The curve doesn't move more to the bottom then seen on the screenshot.