MCG Pro---Fails to retain Flip Trigger Settings

[manashttu]

Hello all from Texas, USA.

I have been enjoying an MCG Pro on my GF MkI for the past week or so. Learned how to set up the brake lever and flip up trigger to activate button presses in addition to serving as axis. Using the latest firmware and VKB software . . . I'm encountering this: when I power off the USB hub or unplug the USB connection, when I re-plug---all my settings for the MCG Pro, including the brake lever button mapping, are retained . . . however, the flip trigger button mapping is lost. I must reload my profile to the stick and all is well again.

I see that the flip trigger axis is different in that it appears to be a virtual axis separate from the 8 physical axis.

Is there a way to have the flip trigger mapping retained as they are for the other axis?

Thanks in advance for any guidance . . .

[fallout9]

Is there a way to have the flip trigger mapping retained as they are for the other axis?

In addition to my reply on Reddit could you post screenshots with Profile/ Axes2Buttons and Profile / Physical Axes?