MCG brake axis wont callibrate

[yojimbosc]

I have an issue where i cannot use 100% of the brake axis on my mcg. It reaches about 53k out of 65535. I have tried moving in the edge deadzone with wizzo gf and just running callibration with both devcfg-c and wizzo gf and the axis still never reaches its maximum. Any advice on how i could manually adjust the edge in devcfg-c

[hon0]

Uhm, check the response curve of that axis. If even a high deadzone doesn't solve the issue then I think the problem is that the response curve have a "Saturation Y" that doesn't go up to 100%. Exemple here :

[yojimbosc]

I actually found my solution after about an hour of trying various options for axis #8. Without any understanding of what the options actually mean I found these settings offered the correct range for the brake.

[fallout9]

Looks like your brake axis is not calibrated. When you're calibrating your MCG Pro you should include the secondary trigger and the brake lever - they are both axes.