VKB-SIM

Hi,

I have two VKB, an SCG Pro left hand, and a MCG Pro right hand, both on Gunfighter 2 bases.

In calibrating the sticks the manual says that KdHi and KdLo MUST be between 100 and 180 and if not to adjust the multiplier to get the range right.

To have the extremes of the axis correctly register around 65535 and 0 I must have values out of that range, e.g for the SCG Y Axis (V_MaRS) I have multiplier set to 9, KdHi to 175, KdLo to 215 (physically reversed input) and bias at 387.

If I set the multiplier to 10 to try and bring that down then KdHi needs to be 88 and KdLo is 107.

Is this expected or a problem?
Is there any way to have a fractional multiplier, e.g 9.5?

Bump

The manual says this for 3-pin D-Mars sensors. When it was written, other sensors simply did not exist. They were only in development. Therefore, it is worth focusing on the MPL digits, which are set after a reset to default.

Ah thanks. So is the short version to adjust MPL for the V_MaRs to get as close to 100-180 as possible, or is there some other optimum ?

Right now depending on my axis I have MPL ranging anywhere from 7 to 15

After resetting to default, the button to the configurator is calibrated and we get approximately such numbers.

Yep, Mine are super similar to that. I'll assume I dont need to manually calibrate then. o7 cmdr ;p Hope alls improving where you are