Need help with stick connectors
Moderator: AdminGroup
-
- Posts: 12
- Joined: Tue Jun 04, 2019 15:17
- Has thanked: 1 time
- Been thanked: 1 time
Need help with stick connectors
Please see the attached pictures. I can't get my GMC Pro to work with my Gunfighter Tabletop base. The Gunfighter Space stick works just fine. It has pins for the connector and the GMC Pro has a flat surface for its connector just like the base. Is there some type of adapter I can get?
-
- Posts: 3263
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Need help with stick connectors
And what kind of grip MCG ordered for their base GunFIghter? You have a Rev.B base, and a grip for Rev.A. Either you did not choose the correct version, or you were sent the wrong thing. Write to the seller and check it out.
-
- Posts: 12
- Joined: Tue Jun 04, 2019 15:17
- Has thanked: 1 time
- Been thanked: 1 time
Re: Need help with stick connectors
Thanks for the reply, more than likely I ordered the wrong part. I don't think that they sell just the base anymore so I'll sell the grip and buy another grip and base together. Thanks again!
-
- Posts: 3263
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Need help with stick connectors
You should write all the same and describe the situation - perhaps they can send only the contact plate in the grip of the desired version. To unscrew the locking screw and replace. I think, it will not be an enormous effort.
Re: Need help with stick connectors
We can get the connector on its way to you - it costs next to nothing (but shipment is still a pain). Write to s a l es @ v k b-sim. pro (remove spaces) and put a link to this very thread in your message. Replacing the connector is no space science, too.
Best Regards,
AeroGator
AeroGator
- rrohde
- Posts: 618
- Joined: Thu Oct 08, 2015 9:28
- Location: USA
- Has thanked: 681 times
- Been thanked: 242 times
Re: Need help with stick connectors
For when the time comes, I've attached the MCG disassembly quick guide to this post. Once you have opened the grip up, the only thing to remove is the connector itself via its two screws, and detach its cable from the PCB. Next, install the new connector, connect its wire to the PCB, and reassemble the grip halves.
- Attachments
-
- MCG-Dissassembly-Quick-Guide.pdf
- (482.65 KiB) Downloaded 200 times
VKB North America
https://VKBcontrollers.com
https://VKBcontrollers.com
- ddrake1984
- Posts: 199
- Joined: Wed May 23, 2018 8:36
- Has thanked: 84 times
- Been thanked: 93 times
Who is online
Users browsing this forum: No registered users and 27 guests