VKB-SIM

1 - Gunfighter Mk.II base + MCG Pro
2 - BlackBox_GF_MCG_PRO_v1_96_B
3 - Default, no changes
4 - Default no changes
5 - VKBDevCfg-C_v0.90.06
6 -
7 -




I have tried with different FW and DevCfg version but I can't seem to calibrate my Rot Z axis. It's either always far right or it just "wanders" around changing values constantly even without any input.

Show a screenshot of the Profile-Axes tab.

I hope this is the right one:

Now everything is clear. With a calibrated axis, digital values cannot be the same in both columns.
Therefore, I propose to put a check in on Partial Calibration in Settings and calibrate only 3,4,5,6,8 axis.
After calibration (changing numbers) everything will fall into place.

Sorry, could you explain this to me like I'm 4 years old

No. 6 = Rot Z axis right? That's the POV button that is not working correctly for me.

Edit - I checked 'Partial Calibration' under the Settings tab. Then only checked 3,4,5,6,8 when I calibrate, but still the same problem.
Edit2 - On the vertical movement on the POV-switch(Rot Z) I'm only getting this much of travel: 42803 to 65535:


On the horizontal movement on the same POV-switch(Slider1) I'm getting full travel(from 0 to 65535)

I do not need a screenshot from the axes test - they do not give anything. Need a screenshot from the Profile-Axes tab after calibration.
It should be something like this.

You have not calibrated the 3rd and 4th axis (microstick Master Mode) - I highlighted them in red in previous messages.

Hmm, ok I think I pushed and touched everything on my stick now



It appears to be working now

Well, that's the result you need. Just need to be properly calibrated.

Thank you!

You're welcome.

Ron61 wrote:Well, that's the result you need. Just need to be properly calibrated.

After an hour of gaming I now have the same problem, the Rot Z is now not calibrated again.
I have tried to re-calibrate it now a couple of time but I'm still getting values like these:

Looking at the screenshot I do not see anything criminal. What confuses him? It seems to be all right. What is the problem?
Show a screenshot of JoyTester, how does the 5.6 axis (microstick Gate Cont) work.

Just got home, have not changed ANYTHING and now its behaving the way it should.

Screenshot of when it's not working:


EDIT - Scratch that. It's already starting to misbehave, not getting full travel of the axis:


Not so much right now, but it's only getting worse.
And it's causing this: