Page 1 of 1
MCG pro axis X off center problem.
Posted: Wed May 15, 2019 18:07
by gavros777
The axis X dot in device config software wont stay centered and the axis x dot shakes erratically at the place it shows in the picture i have attached.
I havent used the stick for months, is this problem fixable?
Re: MCG pro axis X off center problem.
Posted: Wed May 15, 2019 19:28
by fallout9
Try to update first your software and MCG's firmware. The SCG seems fine.
https://vkbcontrollers.com/?page_id=4609
Re: MCG pro axis X off center problem.
Posted: Thu May 16, 2019 5:33
by gavros777
The newer software is missing the axis1 tab, where can i find it?
Re: MCG pro axis X off center problem.
Posted: Thu May 16, 2019 5:41
by gavros777
I just tried the joytester software, i took some screenshots, dont know how to interpret them by the way.
Re: MCG pro axis X off center problem.
Posted: Thu May 16, 2019 6:08
by gavros777
I just updated the firmware and recalibrated, so far problem looks fixed, thank you fallout9!
I had to open the mcg pro stick few months ago to tighten two screws that were loose and this might have mess things up as i didnt recalibrate after.
I thought the problem could be dust build up and would have to open the base and clean it etc etc. You saved me from a lot of work, thanks a lot!