MCG pro axis X off center problem.

Moderator: AdminGroup

gavros777
Posts: 41
Joined: Mon Oct 10, 2016 16:29
Been thanked: 5 times

MCG pro axis X off center problem.

Postby gavros777 » Wed May 15, 2019 18:07

The axis X dot in device config software wont stay centered and the axis x dot shakes erratically at the place it shows in the picture i have attached.

I havent used the stick for months, is this problem fixable?
Attachments
vkb.PNG

User avatar
fallout9
Posts: 5160
Joined: Wed Oct 03, 2018 20:37
Has thanked: 207 times
Been thanked: 1217 times

Re: MCG pro axis X off center problem.

Postby fallout9 » Wed May 15, 2019 19:28

Try to update first your software and MCG's firmware. The SCG seems fine.
https://vkbcontrollers.com/?page_id=4609

gavros777
Posts: 41
Joined: Mon Oct 10, 2016 16:29
Been thanked: 5 times

Re: MCG pro axis X off center problem.

Postby gavros777 » Thu May 16, 2019 5:33

The newer software is missing the axis1 tab, where can i find it?

gavros777
Posts: 41
Joined: Mon Oct 10, 2016 16:29
Been thanked: 5 times

Re: MCG pro axis X off center problem.

Postby gavros777 » Thu May 16, 2019 5:41

I just tried the joytester software, i took some screenshots, dont know how to interpret them by the way.
Attachments
vkb2.PNG
vkb1.PNG

gavros777
Posts: 41
Joined: Mon Oct 10, 2016 16:29
Been thanked: 5 times

Re: MCG pro axis X off center problem.

Postby gavros777 » Thu May 16, 2019 6:08

I just updated the firmware and recalibrated, so far problem looks fixed, thank you fallout9!

I had to open the mcg pro stick few months ago to tighten two screws that were loose and this might have mess things up as i didnt recalibrate after.
I thought the problem could be dust build up and would have to open the base and clean it etc etc. You saved me from a lot of work, thanks a lot!


Return to “Technical Support”

Who is online

Users browsing this forum: Bing [Bot] and 53 guests