VKB-SIM

I bought the Gladiator 2 along with the T rudder pedals just under a month ago. I can't seem to get the rudder pedals working when plugged direct into the joystick. When I run Wizzo and calibrate the pedals indicate either 0 or 32767 or 65535 and nothing between.A mere touch away from the centre position gives the zero or full scale reading. I have tried connecting the rudders via the little orange box to another USB port and that seems fine. Not sure what I am doing wrong. I did have a look at the NJOY32 user guide but to be honest I found plowing through 114 pages of stuff that was flying way over my head a bit daunting. Any help would be appreciated.

The firmware reported by Wizzo seems to be V.0.9.3 [Firmware v1.85.B]

Just a quick update. I ran Njoy32 and tried the calibration in that and the pedals appear to work now plugged directly into the joystick. It looks like the Wizzo calibration couldn't see the pedals properly. The rest of the Njoy32 app still seems a total mystery though. Are there any good Youtube tutorials.

Try to use this manual http://ftp.vkb-sim.pro/Documentations/NJoy32_2_8_En.pdf.