Page 1 of 1
Gunfighter dry clutch question.
Posted: Sat Feb 23, 2019 23:19
by gavros777
I used to think to loosen up the clutch i had to unscrew those two nuts next to a spring from underneath.
Saw a youtube video yesterday showing a silver hex screw on top as the dry clutch that we need to loosen up as it was screwed tight for shipping reasons.
Do i still need to loosen up that hex screw on top or i'm good since i have loosen up the ones from below?
Re: Gunfighter dry clutch question.
Posted: Sun Feb 24, 2019 2:50
by Drano
The dry clutch adjustment screws that are on the bottom are on the Rev A gunfighter. The ones accessible from the top are on Rev B. They improved accessibility where you only had to take off the dust cover vs the bottom plate. I made my own way around this problem when I made a custom bottom plate for my RevA. I included holes where the adjustment screws are so I just lift the stick out of my mount to tweak as needed.
Re: Gunfighter dry clutch question.
Posted: Sun Feb 24, 2019 8:08
by gavros777
Thank you so much!
You just saved me from the frustration of taking the base apart and wonder where are the top hex screws lol.
Re: Gunfighter dry clutch question.
Posted: Mon Feb 25, 2019 15:59
by rtrski
gavros777 wrote:Thank you so much!
You just saved me from the frustration of taking the base apart and wonder where are the top hex screws lol.
If you got a little time, it's honestly not a bad idea to slide the whole gimbal up out of the base assembly and take a look at how the dry clutches work, at least once. Remember to unplug the harness that goes to the cable port before lifting everything out the top!