Gunfighter dry clutch question.

[gavros777]

I used to think to loosen up the clutch i had to unscrew those two nuts next to a spring from underneath.
Saw a youtube video yesterday showing a silver hex screw on top as the dry clutch that we need to loosen up as it was screwed tight for shipping reasons.
Do i still need to loosen up that hex screw on top or i'm good since i have loosen up the ones from below?

[Drano]

The dry clutch adjustment screws that are on the bottom are on the Rev A gunfighter. The ones accessible from the top are on Rev B. They improved accessibility where you only had to take off the dust cover vs the bottom plate. I made my own way around this problem when I made a custom bottom plate for my RevA. I included holes where the adjustment screws are so I just lift the stick out of my mount to tweak as needed.

[gavros777]

Thank you so much!
You just saved me from the frustration of taking the base apart and wonder where are the top hex screws lol.

[rtrski]

Thank you so much!
You just saved me from the frustration of taking the base apart and wonder where are the top hex screws lol.

If you got a little time, it's honestly not a bad idea to slide the whole gimbal up out of the base assembly and take a look at how the dry clutches work, at least once. Remember to unplug the harness that goes to the cable port before lifting everything out the top!