VKB-SIM

Hi,

I'm struggling with the configuration software, it has me totally lost

Is it possible to turn the axis mode button (press and hold to turn POV hat buttons into axis) into a regular button?

If so I'd be super grateful if it could be explained in the simplest terms.

Oh it would be cool if I could use that button to turn the pinkie paddle from an axes to a button, can you do that?

Thanks

Launch VKGdevcfg.exe. Click line #23 cell on Profile - Buttons - Physical layer tab. Select Button instead of uStick switch. Press Set button. That is all. Briefly.
https://drive.google.com/open?id=1ojzm-lJM4BlPHnGRqSdAdqRsSr2yOsIo User manual.
Try and ask questions. If any))
Be lucky!

I was just wondering about this, too. Thanks.

Victorus wrote:Launch VKGdevcfg.exe. Click line #23 cell on Profile - Buttons - Physical layer tab. Select Button instead of uStick switch. Press Set button. That is all. Briefly.
https://drive.google.com/open?id=1ojzm-lJM4BlPHnGRqSdAdqRsSr2yOsIo User manual.
Try and ask questions. If any))
Be lucky!

Thanks, got the button to go from mode switch to normal button.

Can't figure out if you can switch an axis, to axis-to-button on the fly using one of the many functions though

If you turn on A2B checkbox your axes still work as usually AND virtual buttons will be "pressed" as an axis runs. I use this, for example, to indicate axis position with LEDs. The simpliest LED event is Axis in center. Or its inversion. As buttons are consequently pressed and released, corresponding LEDS flash. Or change light mode (color, brightness, frequency).

That's cool, got it figured out in the end, thanks very much