Can't get anything other than X and Y axis to work on GF + MCG Pro
Posted: Sun Dec 02, 2018 9:59
So I just finally got around to mounting my Gunfighter base to my sim pit and attached the MCG Pro grip and hooked it up to my computer.
I downloaded all the recent manuals and software and went through the blackbox manual for the set up. I flashed the "_BlackBox_GF_MCG_PRO_v1_94_B.vkb" file and restarted.
However when I went back into the VKBDevCfg-C program, I tried running calibration, but the only axes that got any response were X and Y.
I tried in Wizzo and it also only gets any input from Roll and Pitch. VKB joytester only gets X and Y input as well.
None of the other axes and buttons get any sort of response when I use them in any of those programs.
I'm not sure if I'm just missing something that I need to do or not.
I downloaded all the recent manuals and software and went through the blackbox manual for the set up. I flashed the "_BlackBox_GF_MCG_PRO_v1_94_B.vkb" file and restarted.
However when I went back into the VKBDevCfg-C program, I tried running calibration, but the only axes that got any response were X and Y.
I tried in Wizzo and it also only gets any input from Roll and Pitch. VKB joytester only gets X and Y input as well.
None of the other axes and buttons get any sort of response when I use them in any of those programs.
I'm not sure if I'm just missing something that I need to do or not.