Hi , just got my MCG PRO rev A Grip, i followed the guide for GF MKi owners and flashed the firmware , i did reset but i am unable to calibrate the stick, base is working properly but not the stick see pic
should these two firmware versions be the same?
Gunfighter MK1 with MCG PRO
Moderator: AdminGroup
-
- Posts: 3277
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Gunfighter MK1 with MCG PRO
Of course, if there is a coincidence of the version of the handle and the base. In the version "A" on the base there is a connector of the type "father", in the handle, respectively, of the type "mother". And in the version “B” everything is the opposite - on the basis of “mom”, in the grip - “dad”.
-
- Posts: 3277
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Gunfighter MK1 with MCG PRO
You can find a mate for this connector on Aliexpress and insert it into the handle. You can generally bite everything and wire directly. You can in different ways.
But you can write to sales@vkb-sim.pro and try to buy a stock with a connector for your revision handle. But version B is better,that and future products could use.
But you can write to sales@vkb-sim.pro and try to buy a stock with a connector for your revision handle. But version B is better,that and future products could use.
Who is online
Users browsing this forum: No registered users and 101 guests