VKB-SIM

Hi , just got my MCG PRO rev A Grip, i followed the guide for GF MKi owners and flashed the firmware , i did reset but i am unable to calibrate the stick, base is working properly but not the stick see pic

should these two firmware versions be the same?

found the problem, was mounted too tight

Wait, then this MCG A grip could be mounted on Gladiator pro MK1 without any additional adapters?

Of course, if there is a coincidence of the version of the handle and the base. In the version "A" on the base there is a connector of the type "father", in the handle, respectively, of the type "mother". And in the version “B” everything is the opposite - on the basis of “mom”, in the grip - “dad”.

Это гладиатор 1 про. Могу ли я монтировать базу MCG pro revA на ней без адаптера?

You can find a mate for this connector on Aliexpress and insert it into the handle. You can generally bite everything and wire directly. You can in different ways.
But you can write to sales@vkb-sim.pro and try to buy a stock with a connector for your revision handle. But version B is better,that and future products could use.