Gunfighter MK1 with MCG PRO

Moderator: AdminGroup

FoxDelta
Posts: 15
Joined: Sat Mar 04, 2017 8:36
Been thanked: 2 times

Gunfighter MK1 with MCG PRO

Postby FoxDelta » Mon Oct 08, 2018 12:39

Hi , just got my MCG PRO rev A Grip, i followed the guide for GF MKi owners and flashed the firmware , i did reset but i am unable to calibrate the stick, base is working properly but not the stick see pic

should these two firmware versions be the same?
Attachments
status.png

FoxDelta
Posts: 15
Joined: Sat Mar 04, 2017 8:36
Been thanked: 2 times

Re: Gunfighter MK1 with MCG PRO

Postby FoxDelta » Mon Oct 08, 2018 12:47

found the problem, was mounted too tight

blackram
Posts: 104
Joined: Tue Mar 13, 2018 15:26
Been thanked: 13 times

Re: Gunfighter MK1 with MCG PRO

Postby blackram » Thu Oct 11, 2018 11:56

Wait, then this MCG A grip could be mounted on Gladiator pro MK1 without any additional adapters?

Ron61
Posts: 1455
Joined: Tue Jan 15, 2013 23:56
Location: г.Минск
Has thanked: 31 times
Been thanked: 314 times

Re: Gunfighter MK1 with MCG PRO

Postby Ron61 » Thu Oct 11, 2018 14:11

Of course, if there is a coincidence of the version of the handle and the base. In the version "A" on the base there is a connector of the type "father", in the handle, respectively, of the type "mother". And in the version “B” everything is the opposite - on the basis of “mom”, in the grip - “dad”.

blackram
Posts: 104
Joined: Tue Mar 13, 2018 15:26
Been thanked: 13 times

Re: Gunfighter MK1 with MCG PRO

Postby blackram » Thu Oct 11, 2018 17:02

Это гладиатор 1 про. Могу ли я монтировать базу MCG pro revA на ней без адаптера?
Attachments
maxresdefault.jpg

Ron61
Posts: 1455
Joined: Tue Jan 15, 2013 23:56
Location: г.Минск
Has thanked: 31 times
Been thanked: 314 times

Re: Gunfighter MK1 with MCG PRO

Postby Ron61 » Fri Oct 12, 2018 11:59

You can find a mate for this connector on Aliexpress and insert it into the handle. You can generally bite everything and wire directly. You can in different ways.
But you can write to sales@vkb-sim.pro and try to buy a stock with a connector for your revision handle. But version B is better,that and future products could use.


Return to “Technical Support”

Who is online

Users browsing this forum: Bing [Bot] and 2 guests