Incorrect microstick configuration.
Carefully look at the picture.
For the first, the numbers are correctly set, and for the second one there should be 6 and 5.
Black box still flashing after attaching MCG to Gunfighter
Moderator: AdminGroup
Re: Black box still flashing after attaching MCG to Gunfighter
I have set up using the following settings below. I no longer see AXIS for these mini sticks which is good.
The problem I have now is when I press Master mode up I get button 14 and 30 together, all other directions and centre button are as I want them. The Gate Cont still only registers the centre but none of the directions.
The problem I have now is when I press Master mode up I get button 14 and 30 together, all other directions and centre button are as I want them. The Gate Cont still only registers the centre but none of the directions.
Re: Black box still flashing after attaching MCG to Gunfighter
I made changes as you suggested, but still not as I need for my configuration. I now get two presses again, and also the Gate Cont still does not register a press. Also button 24 stays lit now.
-
- Posts: 3276
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Black box still flashing after attaching MCG to Gunfighter
Well, how should it work if not assigned? You can go two ways - reset to default and then a switch appears for MasterMode or assign this button in the current profile.
Re: Black box still flashing after attaching MCG to Gunfighter
still does not work.
BTW I have no knowledge of how your configuration software works, everything I have done is from reading what other have tried. Lack of clear step by step guides on how to achieve desired profiles really leaves me confused on how to create the profile I want.
Re: Black box still flashing after attaching MCG to Gunfighter
I want to use this stick primarily for DCS.
I want the Master mode to be buttons not axis. I will use this for targeting slew.
I want the Gate Cont to be buttons, not axis. I will use this for trimmer.
Everything else is as I want it.
I am happy to reset and start over.
I want the Master mode to be buttons not axis. I will use this for targeting slew.
I want the Gate Cont to be buttons, not axis. I will use this for trimmer.
Everything else is as I want it.
I am happy to reset and start over.
Re: Black box still flashing after attaching MCG to Gunfighter
As long as it can detect this in DCS as single key presses for 4 directions up, down, left, right and centre, on both mini sticks, I do not care how it is achieved.
-
- Posts: 3276
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 44 times
- Been thanked: 637 times
Re: Black box still flashing after attaching MCG to Gunfighter
Remove the Pov-Axes switch and make a simple button out of it. Do not forget after this (or before that), calibrate all axes. Including a flip-up trigger.
You can choose the number of hat directions - 4way or 8way. It's simple, it seems difficult only at first glance.
Video here.
You can choose the number of hat directions - 4way or 8way. It's simple, it seems difficult only at first glance.
Video here.
Who is online
Users browsing this forum: No registered users and 79 guests