Gunfighter KG12 - X-axis not work correctly
Posted: Wed Aug 29, 2018 21:43
I have been using my Gunfighter since August without any problem, but suddenly x-axis not work correctly: I cannot perform full deflection to the right even if my grip is full right and x-axis indicator erratically moves.
I tried to recalibrate it but the error is still there.
The detailed description of the problem:
While I fluently and slowly move grip to the right, the indicator suddenly stops moving in the last quarter of the path towards the right side and/or started to erratically oscillate. I cannot perform full deflection to the right. The deflection to the left is OK (fluent and precise). Y-axis is OK as well.
See attachment - you can see x-axis indicator while my grip is full right
I use VKB Device Config v.0.87.05.
BTW: while I tried to solve the problem I mistakenly flashed firmware from BlackBox 1_94B - this firmware is not for KG12 but for MCG. Where can I download the firmware for KG12?
Thanks for help.
EDIT: I also tried the advice from this post http://forum.vkb-sim.pro/viewtopic.php?f=25&t=3235: I unplug and plug again the X-axis connector (see attachment). But after plugging device to USB port and set the device to Default and then calibrating - no change :-/
Note: I use very soft springs (custom made) - they are softer than the softest default springs no. 10
I tried to recalibrate it but the error is still there.
The detailed description of the problem:
While I fluently and slowly move grip to the right, the indicator suddenly stops moving in the last quarter of the path towards the right side and/or started to erratically oscillate. I cannot perform full deflection to the right. The deflection to the left is OK (fluent and precise). Y-axis is OK as well.
See attachment - you can see x-axis indicator while my grip is full right
I use VKB Device Config v.0.87.05.
BTW: while I tried to solve the problem I mistakenly flashed firmware from BlackBox 1_94B - this firmware is not for KG12 but for MCG. Where can I download the firmware for KG12?
Thanks for help.
EDIT: I also tried the advice from this post http://forum.vkb-sim.pro/viewtopic.php?f=25&t=3235: I unplug and plug again the X-axis connector (see attachment). But after plugging device to USB port and set the device to Default and then calibrating - no change :-/
Note: I use very soft springs (custom made) - they are softer than the softest default springs no. 10