T-Rudder MkIV RJ45 Connector
Posted: Tue Jul 10, 2018 21:23
I plug my T-Rudder MkIV directly into my Gladiator MkII -- works great. Unfortunately, the plastic pin that holds the T-Rudder's RJ45 plug into the jack on the joystick has broken off. If I use tape to hold the plug in the jack it works fine, but this is not an ideal solution. Ideally, I'd like to replace the T-Rudder's plug.
It appears that the plug is loaded as a standard 568B. Before I cut the end off the cable to replace it, though, I wanted to test the wiring. First I put together a straight-through jumper with a plug at one end and a jack at the other (both sides to the standard 568B). The jumper tested properly, but I didn't get a reading when I tested the T-Rudders/Gladiator on the VKB JoyTester. Perhaps the T-Rudder cable + the jumper cable was too long? Could there be a different issue? Should I jump right in and cut the end off the broken plug?
Thanks.
It appears that the plug is loaded as a standard 568B. Before I cut the end off the cable to replace it, though, I wanted to test the wiring. First I put together a straight-through jumper with a plug at one end and a jack at the other (both sides to the standard 568B). The jumper tested properly, but I didn't get a reading when I tested the T-Rudders/Gladiator on the VKB JoyTester. Perhaps the T-Rudder cable + the jumper cable was too long? Could there be a different issue? Should I jump right in and cut the end off the broken plug?
Thanks.