VKB-SIM

Thanks. Flashing, Calibrating and then testing it is working!!

I need to setup all of my other settings and test them all to make sure all of the other stuff is still working. But this looks great so far!!

Thanks Alex!
And thanks for the reply and support Ron!!

Cheers!

I have this setup in my custom profile now and it seems to all be working fine.

The only problem that I encountered was when I was done setting everything up, I tried to set my "Response Curves" for Axes 3&4. I wanted a slow/low curve to move the Target Designation cursor in DCS. I've used this curve in previous versions of the firmware...

But when I setup my Response Curve and 'Set' it to the stick, the Master Mode POV Hat would stop working. It would work one time and then stop.

After a bit of testing I found the problem. If in any curve, you set the last 100% value too low, the POV hat on that Axis fails. The last value defaults to 128. It's best to just leave it at 128. (I could change it to 63 in previous version's of the firmware).