Is it possible to combine one absolute axis and one relative axis?

Moderator: AdminGroup

Snacko
Posts: 90
Joined: Sat Apr 21, 2018 0:24
Has thanked: 9 times
Been thanked: 8 times

Re: Is it possible to combine one absolute axis and one relative axis?

Postby Snacko » Fri Nov 23, 2018 23:59

Thanks. Flashing, Calibrating and then testing it is working!!

I need to setup all of my other settings and test them all to make sure all of the other stuff is still working. But this looks great so far!!

Thanks Alex!
And thanks for the reply and support Ron!!

Cheers!

Snacko
Posts: 90
Joined: Sat Apr 21, 2018 0:24
Has thanked: 9 times
Been thanked: 8 times

Re: Is it possible to combine one absolute axis and one relative axis?

Postby Snacko » Wed Nov 28, 2018 21:52

I have this setup in my custom profile now and it seems to all be working fine.

The only problem that I encountered was when I was done setting everything up, I tried to set my "Response Curves" for Axes 3&4. I wanted a slow/low curve to move the Target Designation cursor in DCS. I've used this curve in previous versions of the firmware...

But when I setup my Response Curve and 'Set' it to the stick, the Master Mode POV Hat would stop working. It would work one time and then stop.

After a bit of testing I found the problem. If in any curve, you set the last 100% value too low, the POV hat on that Axis fails. The last value defaults to 128. It's best to just leave it at 128. (I could change it to 63 in previous version's of the firmware).

curve.png


Return to “Technical Support”

Who is online

Users browsing this forum: Google [Bot] and 41 guests