Page 1 of 1
MCG Pro X Axis Spiking
Posted: Thu Apr 19, 2018 3:27
by Wrong Way
Hello, I'm getting terrible spiking in the x-axis
Model: VKBGF002 Rev MKII
Firmware: BB GF v1.91.1
Springs: x #50, y #50
Cams: #10
Software: Device Config v0.83.85, ZBootloader-C v1.11
MCG Pro X Axis Spiking
Posted: Thu Apr 19, 2018 12:40
by Ron61
Show screenshots of tabs of physical and logical axes.
MCG Pro X Axis Spiking
Posted: Fri Apr 20, 2018 0:56
by Wrong Way
Sorry, I could only post three images for some reason, then had to wait for the moderator.
MCG Pro X Axis Spiking
Posted: Fri Apr 20, 2018 1:00
by Wrong Way
More screen caps.
MCG Pro X Axis Spiking
Posted: Fri Apr 20, 2018 11:07
by Ron61
I can advise you to install extreme beta versions of the
configurator and
firmware.
1. add the lines in the corresponding sections to the zconfig.ini file (which will appear after the first launch of the configurator in the folder where it is installed), as in the screenshot
2. after restarting the configurator, reset the settings to default, which appeared with the same name button
3. make calibration on all axes
4. if there are unused axes (for example, TRudder is not directly connected to the BlackBox Gunfighter - this is the 7th physical axis), then in the Input, set Virtual for them (now there is D-Mars)
MCG Pro X Axis Spiking
Posted: Fri Apr 20, 2018 17:50
by YAGA
I had the exact same issue, as have many others. Mine was fixed by replacing the wiring between the USB pass through and the board. It also fixed phantom button presses.
MCG Pro X Axis Spiking
Posted: Sat Apr 28, 2018 16:43
by Wrong Way
The beta firmware seems to have solved the problem. I've been using the joystick with the new firmware for three days, and I haven't had the problem.
Thank you so much!
MCG Pro X Axis Spiking
Posted: Sat Apr 28, 2018 18:40
by Ron61
You're welcome.