MCG Pro Roll Axis Jumping

Moderator: AdminGroup

redribbon
Posts: 127
Joined: Fri Mar 03, 2017 13:04
Has thanked: 64 times
Been thanked: 24 times

Re: MCG Pro Roll Axis Jumping

Postby redribbon » Thu Aug 23, 2018 2:57

Ok fixed the problem, disconnected the connector (previously it would come off completley from board pins)and separate two plastic parts apart than fixed lose one back into board pins, seems this time pins locked nicely into the plastic part of the connector.
I was worried about plastic part come of from board pins while joystick is still under warranty so i didn't want to mess with it (board pins are sensitive).
Now it's firm with stable connection, working fine for hours.

User avatar
AeroGator
Posts: 430
Joined: Wed May 31, 2017 7:40
Has thanked: 107 times
Been thanked: 179 times

Re: MCG Pro Roll Axis Jumping

Postby AeroGator » Thu Aug 23, 2018 5:13

redribbon wrote:while joystick is still under warranty

Our flight gear remains under warranty for lifetime.
This does not, of course, mean that users are encouraged to bang the joysticks against concrete blocks - but it has always been our point that you may (and often, should) know what is inside, and never be afraid of doing some basic manipulations on the gear.

Glad it worked out with you.
Don't hesitate to write again if anything goes wrong.
Best Regards,
AeroGator

YAGA
Posts: 20
Joined: Wed Jan 31, 2018 20:41
Been thanked: 2 times

Re: MCG Pro Roll Axis Jumping

Postby YAGA » Thu Sep 27, 2018 10:20

I'm still having this issue. Seems to be entirely due to cables becoming unseated. This wouldn't be a huge problem if it were not for the fact that i have to open the stick up on a near daily basis to re-seat.

Seems other people are having this issue and that it has been nailed down to unseated cabling. How should i proceed?

User avatar
AeroGator
Posts: 430
Joined: Wed May 31, 2017 7:40
Has thanked: 107 times
Been thanked: 179 times

Re: MCG Pro Roll Axis Jumping

Postby AeroGator » Thu Sep 27, 2018 12:47

YAGA wrote:How should i proceed?

Always the best first move will be to open a ticket at the dealership you bought the device from.
They will be the fastest to help if it comes to parts replacement.
Even if not, they will be faster because of the same time belt.
Best Regards,
AeroGator

YAGA
Posts: 20
Joined: Wed Jan 31, 2018 20:41
Been thanked: 2 times

Re: MCG Pro Roll Axis Jumping

Postby YAGA » Thu Sep 27, 2018 18:23

Okay, I'll open a ticket about this. Still hoping I can solve my other issue without replacement parts.


Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 4 guests