Page 1 of 1

Gladiator calibration messed up cannot fix

Posted: Fri Jan 19, 2018 18:39
by scoobywan
1 - Gladiator Mk.II (WWII KG12 Grip Replica (non-removable))
2 - v1.85B
3 - Default
4 - Default
5 - Wizzo v0.88, VKB Device config v0.83.96 (Njoy32 firmware v1.91)

6 - joytester screen
joytest.GIF

7 - Vkbdevcfg-c screen
config.GIF



After trying to calibrate my Gladiator with wizzo (i had put all deadzones to zero and ran calibration, which seem to reset back to default when restarting wizzo) the stick is now stuck with incorrect center. i tried to re-calibrate multiple times doing the following:
Load Wizzo
click start
move all axis to extremes
click stop
wizzo says it restarts but only shuts down.

tried in config tool:
click default
click "set"
click start calibration
move axis to extremes
click end calibration

after multiple attempts nothing i do changes the incorrect center position, i cannot use this stick now.
please help.

Re: Gladiator calibration messed up cannot fix

Posted: Fri Jan 19, 2018 19:47
by Ron61
It is necessary to update the firmware, choose from the archive for your device. Screenshots of the Profile-> Common-n-axis tab will not be superfluous.

Re: Gladiator calibration messed up cannot fix

Posted: Sat Jan 20, 2018 0:36
by scoobywan
i did "reset to default" in windows game controller settings and it fixed the off center problem!

now i have another problem that when i load the bootloader to up my firmware, it says "device not connected" and i cannot flash. but the device IS connected and working so why it says disconnect in bootloader?