X axis on GF not calibrating fully
Posted: Sat Jan 13, 2018 9:02
*EDIT* did calibration 3 separate times as well as restart computer before posting on forums *End Edit*
Hey folks, I just got my MK1 Gunfighter with MCG Pro mounted and connected today. Everything went well during the install and calibration, lights on the black box blue and green, great. Then when I go to test Axes I can see that Axis X zeros out before I stop moving to the left. It feels like 25% of that axis movement isn't being registered. I'm getting full registration on the right side movement of Axis X and all other Axis. (is the foldable trigger supposed to be an axis? I'm not getting any movement when I depress the foldable trigger either). I haven't modified the profile parameters or anything, this is just installing default configuration before calibration.
1 - Device model and version: Gunfighter MK.1 w/ MCG Pro
2 - Controller Firmware version: VKBsim Gunfighter Modern Combat PRO v1.91E
3 - Number and type of springs used: 1 each of #30
4 - Тype of cams used: #30 on both axes
5 - If VKB original software is used, please always mention its version: VKBDevCfg-C_v0_83_9_6
6 - Vkbjoytester screenshots.
https://sta.sh/0owtwfuw2bc
7 - Vkbdevcfg-c screenshots.
https://sta.sh/08e2dlfwjts
https://sta.sh/0nj6vwnfjlg
https://sta.sh/0vggr5yd0sk
Hey folks, I just got my MK1 Gunfighter with MCG Pro mounted and connected today. Everything went well during the install and calibration, lights on the black box blue and green, great. Then when I go to test Axes I can see that Axis X zeros out before I stop moving to the left. It feels like 25% of that axis movement isn't being registered. I'm getting full registration on the right side movement of Axis X and all other Axis. (is the foldable trigger supposed to be an axis? I'm not getting any movement when I depress the foldable trigger either). I haven't modified the profile parameters or anything, this is just installing default configuration before calibration.
1 - Device model and version: Gunfighter MK.1 w/ MCG Pro
2 - Controller Firmware version: VKBsim Gunfighter Modern Combat PRO v1.91E
3 - Number and type of springs used: 1 each of #30
4 - Тype of cams used: #30 on both axes
5 - If VKB original software is used, please always mention its version: VKBDevCfg-C_v0_83_9_6
6 - Vkbjoytester screenshots.
https://sta.sh/0owtwfuw2bc
7 - Vkbdevcfg-c screenshots.
https://sta.sh/08e2dlfwjts
https://sta.sh/0nj6vwnfjlg
https://sta.sh/0vggr5yd0sk