MCG loose base

Moderator: AdminGroup

User avatar
VampireNZ
Posts: 4
Joined: Tue Jun 20, 2017 10:32
Been thanked: 5 times

Re: MCG loose base

Postby VampireNZ » Thu Mar 28, 2019 10:25

I have also just recently wondered why my grip was so wobbly - fouond this thread and took my MCG grip apart and yes - both the screws holding the plastic clamp piece at the base of the stick were very loose. Tightened them up as much as I dared, but didn't think of some lock washers. No doubt it will get loose again and require re-tightening.

Now if i could just figure out why my red 'Stick' light is flashing! Interestingly enough I actually tried the v1_96_B firmware and it was green....but I had no hat switches working lol. Reverted to v1_96_0 as a flashing red light and working hat switches is a much better result!


Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 36 guests