Gladiator Pro and T-Rudder Output Signal

Moderator: AdminGroup

Monroe07
Posts: 5
Joined: Fri Dec 01, 2017 23:57

Gladiator Pro and T-Rudder Output Signal

Postby Monroe07 » Tue Dec 12, 2017 2:19

I have noticed that both the Gladiator Pro and the T-Rudder MK. IV use the same sensor board.
MaRS Sensor Board.JPG
(30.47 KiB) Not downloaded yet
post-979-0-59080900-1468647776.jpg


I know that the MaRS Sensor (KMZ41) has an analog output, but the Sensor is connected to the "BlackBox" through an unmarked 2-row 8-pin Square IC Chip and a 550 ohm resistor. I have 2 questions, an answer (Other than its a "secret" or that it is impossible) to either would be extremely helpful for me to use the pedals in a project of mine.

What is the second, unmarked, square IC that is connected to the signal pin? (side-note: while it converts the analog signal from the MaRS sensor to a digital square wave, it doesn't appear to be an Analog-to-Digital Converter from the looks of its wave form on an oscilloscope or in practice)

What is the protocol that the unmarked chip converts the analog sensor data into?
Attachments
Mars 4.0.jpg

Return to “Technical Support”

Who is online

Users browsing this forum: Bing [Bot] and 4 guests