I have noticed that both the Gladiator Pro and the T-Rudder MK. IV use the same sensor board.
I know that the MaRS Sensor (KMZ41) has an analog output, but the Sensor is connected to the "BlackBox" through an unmarked 2-row 8-pin Square IC Chip and a 550 ohm resistor. I have 2 questions, an answer (Other than its a "secret" or that it is impossible) to either would be extremely helpful for me to use the pedals in a project of mine.
What is the second, unmarked, square IC that is connected to the signal pin? (side-note: while it converts the analog signal from the MaRS sensor to a digital square wave, it doesn't appear to be an Analog-to-Digital Converter from the looks of its wave form on an oscilloscope or in practice)
What is the protocol that the unmarked chip converts the analog sensor data into?
Gladiator Pro and T-Rudder Output Signal
Moderator: AdminGroup
Who is online
Users browsing this forum: No registered users and 127 guests